How to create a 3D jewellery set

What you need:

Results – These can be various based on personal choices:

Instruments:               

Directions:

1. To start with you will have to have to saw/file the sprue off the sections
2. You can pre buff/ pre polish the star parts which makes cleaning easier after soldering
3. Making use of buff sticks to buff back again the cast end going from coarse to high-quality
4. At the time you have acquired to fine buff paper you can begin to polish making use of luxi compound –blue for first phase with the calico mop
5. There are tutorial marks on the position of the star pendant and earrings you want to solder bounce rings to
6. You can file leap rings with triangular file to give them an angle at the finishes so they sit flat from the level of the star
7. Utilize solder paste where by the information marks are on the stars
8. On the soldering block, push the soar ring in opposition to the stars manual marks and use tweezers to maintain the leap ring in position
9. Using the hand torch, warmth up the strong star and the moment it is beginning to flip colour slowly move together to the bounce ring so it receives to tempreture at similar time until eventually the solder melts and joins the items jointly
10. Quench and place it in pickle, rinse soon after pickling to wash off acids.
11. If you didn’t buff and pre polish previously now you will require to buff back the cast complete and if you will need to remove any additional solder
12. Polish the piece utilizing luxi compound – blue for initially phase employing a calico mop
13. Then polish with White luxi compound and a fluffy mop
14. For your earrings you can open up up your ear wire and then shut it again with each other
15. For the star pendant necklace, dependent on the bail you decide on you can both include it right the the leap ring or if essential you may want to insert a different more compact jump ring prior to the bail.
16. Ultrasonic or thoroughly clean off any residual polish and incorporate a chain to the pendant.

Optional: you can either completely close your findings by soldering them all through soldering action 9 or depart the findings semi open up and just pushed together .

Save this for later on